Simulink PID autotuning problem
27 vues (au cours des 30 derniers jours)
Afficher commentaires plus anciens
Pedja
le 13 Avr 2014
Réponse apportée : Mudit Verma
le 30 Août 2020
Hi, I have tried simple PID auto tuning function, but I'm getting rather strange result. I have attached mdl file, so You can maybe point to me where I'm doing wrong.
Pete
P.S. Sorry if question sounds stupid, I'm a newbie in Matlab/Simulink world
0 commentaires
Réponse acceptée
Arkadiy Turevskiy
le 16 Avr 2014
There is nothing wrong or strange with your model. You did not provide op_trim1 operating point that your model uses, so I just initialized the integrator in PID block at 6.37 (I can explain how I did this if you want) - basically to get rid of a large initial transient.
Once I did that, and ran the simulation with your PID gains, I got a reasonable response:
Another note: as gravity is somethign that does not change much, you can just add a constant feedforward term to your controller to compensate for it. Then, even if gravity changes a bit as you change locations, PID will do a good job compensating for that:
0 commentaires
Plus de réponses (3)
Arkadiy Turevskiy
le 16 Avr 2014
Modifié(e) : Arkadiy Turevskiy
le 16 Avr 2014
Ok, here is how I got that integrator initial condition.
First I added Trim Output Constraint on the "height" signal. To do that, right click on the signal, and specify Trim Output Constraint, as shown below.
Next, launch Linear Analysis Tool:
Now, we want to trim the model:
Click to specify the trim conditions:
All states should be in steady state:
The output (height) should be at 0:
Click "trim". Tool computes the operating condition op_trim1. Examine it to see the value for Integrator in the PID Controller:
All of this can also be done with a few lines of code:
model = 'Proba_3';
opspec = operspec(model);
opspec.Outputs(1).Known = true;
findop(model,opspec)
0 commentaires
jashandeep kaur
le 11 Mar 2017
may i know how does auto tunning take place?how does controller calculate the desired values of P and I?is there any method or algo?
0 commentaires
Mudit Verma
le 30 Août 2020
Autotuner not working in my model there is no PId gains showing they are showning 0 and only frequencies are showing in display block
i have attached my model plzz see and give me solution to my prob.
0 commentaires
Voir également
Produits
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!